Modell 241, Typecode: 241-V-LS-E2-DD-PV1L-V4LH-ST-MP0-CF

Durchflussmesser

Technische spezifikation:

Vortex Flow Meter TAG data ( M 3 - 3 - 2 ): Fluid: Water installed Pipe size: 54 inch Exact Pipe i.d.: 52,5 Inch Pressure: 0,1-1 bar g Temperature: 19-50 °C Density: 998,5 kg/m³ Viscosity: 1,03 mPas Flow range: 8100-9000 Acm³/h 1,28-1,42 m/sec Cal. Range: 0-12000 Acm³/h Insertion Vortex Mass Flow Meter - Modell 241 Typecode: 241-V-LS-E2-DD-PV1L-V4LH-ST-MP0-CF Industrial Insertion Vortex Flow Meter. For Mass flow Measurement of Liquids, Gases and Steam Please insure that at the point of installation an evenly distributed flow profile exists (long enough up and downstream piping). This requirement is essential to establish best possible metering results! 4-wire electronics standard. (2-wire optional). Hazardous Area version, FM or ATEX approved. The insertion vortex meter is available (optional) with a retraction tool and can be installed or deinstalled on pressurized pipe lines. Base version with following limitations: Operating temperature: -40 to +260°C (higher-optional) Operating pressure: up to 100 bar (depending on version) (Other temperatures and pressures available optional!) Equipped as follows: V Version: Velocity and / or volumetric flow sensor LS Probe: Standard length probe E2 Enclosure: NEMA 4 x (IP 65) enclosure, mounted directly on the probe. DD Display: Digital Display with push but tons PV1L Power supply: 18 - 36 VDC in connection with 2-wire operation V4LH Outputs: 1 Analog output (4-20 mA), HART Communication, two wire System, 1 Pulse output ST Temp. range: operating range -40°C to 260°C. MP0 Process pressure: Without pressure transducer (when application VT is required ) CF Process connect.: Compression Fitting on 2-inch 150 lb Flange.

Wir verkaufen nur neue und originelle Produkte!